The PM70/CA45 combo molding was just the ticket for a small powder room re-model. The embossings are deep and defined and still showed well after a couple of coats of primer sealer and 3-4 coats of latex enamel. We found it easier to lay them flat and glue the two pieces together (these were only 5' runs) to cut the mitered return as the top piece doesn't have a defined flat area since it's designed to pivot tight against the wall....it made for cutting both pieces separately impractical. This is just an installation comment and the cuts were easily accomplished with a 10" compound miter saw. We love the look of the new molding!